Explanation for drawn cup needle roller bearing
 
 
Introduction
Drawn cup needle roller bearings is formed with thin steel plate through precision punching with very sectional
height and big load capacity. This kind of bearings are especially applicable to the big quantity production with
economic demands.
Stable combination is used between the needle bearings and the bearing cage. No axle fixture is required.
Even under high speed and heavy load condition, the bearing functions can be fully maintained. Furthermore,
no lubricating for a long time is possible due to its high storage volume of grease.
 
Structure
HK,HKH Drawn cup needle roller bearings with open ends
HK...RS Drawn cup needle roller bearings with open ends, single side sealing
HK...2RS Drawn cup needle roller bearings with open ends, double sides sealing
BK,BKH Drawn cup needle roller bearings with closed ends
BK...RS Drawn cup needle roller bearings with closed ends, single side sealing
MF,MFH Drawn cup needle roller bearings with closed ends, tip full complement needle roller type
MFY Drawn cup needle roller bearings with closed ends,flat head full complement needle roller type
F,FH Drawn cup needle roller bearings with open ends, tip full complement needle roller type
FY Drawn cup needle roller bearings with open ends, flat head full complement needle roller type
SCE Inch drawn cup needle roller bearings with open ends
BCE Inch drawn cup needle roller bearings with closed ends
Drawn cup needle roller bearings
Drawn cup needle roller bearings is composed of thin wall punched outer ring, retainer and a group of needle
rollers.To compare with the Piercing drawn cup needle roller bearings with open ends, this is a kind of sealed
bearing with one end sealed. This kind of bearings are applicable to the shaft ends with small axial moving force.
Sealed drawn cup needle roller bearings
The sealed drawn cup needle roller bearings has a sealing lip.Under general condition,it can protect the dirt
from entering into the bearing and the lubricant leakage. The sealing ring is made of compound rubber with
operational filled with quality lithium based grease when supplied. Furthermore the standard designing of the
drawn cup needle roller bearing is non-oil hole, while the double row drawn cup needle roller bearings are
designed with the standard of oil holes. Should there be any option, please notice us in orders.
Full complement needle roller type drawn cup needle roller bearings
This kind bearings are composed of full width needles which extend outside of the outer rings. Therefore it will
sustain heavy load and is suitable for the rocking action of low and medium speed. The bearings can be used
instantly once it is assembly because lubricating grease is filled in the bearing before supplied.
 
Mounting
The outer ring of the drawn cup needle roller bearings made of thin steel plate through punching will reach the correct shape and dimension precision,when it is pressed into the bearing cage.Therefore,the dimensional precision and the shape of bearing cage will directly effect the inscribed circle of the bearing. Thus enough attention must be attached to the size and shape of the bearing cage.
A=D-(0.2--0.3)mm
B=Fw-(0--0.025)mm
In mounting this kind of bearings, it will be easier to use the pressing core shaft as illustrated in the figure.Special tool must be used to press on the side with printed code mark to compress get the bearings fitted when assembling.Direct hammer tapping is strictly forbidden.The core shaft must be made as per the requirements shown below.
 
The inspection of the drawn cup needle roller bearings
In regard to the dimension inspection of this kind of needle bearings,it is meaningless to measure the single
bearing because the bearing will deformed after quenching due to its thin outer ring wall. That is:this kindof
needle bearings must be fitted into the bearing cage according to the recommended permissible tolerances
before it can reach the vital functional inscribed circle and circularity. So, the following inspection methods
are recommended:
(1) press the bearing into basic gauge with rigidity shown in the list (the wall thickness is no less than 20mm) .
(2) check with a feeler gage or taper gage the inscribed circle to see if it falls in the required range
 
[CLOSE]